In Rhode Island, a truck and load can be 8 ft 6 in wide, 13 ft 6 in high and 80,000 lb gross without a permit, with a semitrailer up to 53 ft long on Interstates and designated highways. Anything bigger or heavier needs an oversize/overweight permit from the Rhode Island Department of Transportation (RIDOT). You order it online in the RIDOT OSOW Permit Portal, and the Oversize & Overweight Division answers questions at (401) 563-4582.
One Rhode Island route needs special attention right now: I-195's Washington Bridge in Providence. RIDOT's restrictions page bars oversize vehicles from the bridge until an anticipated December 2028. RIDOT's permit portal, however, says oversize loads can request a crossing between 11 p.m. and 5 a.m. on Sunday, Monday or Wednesday nights. Confirm with the permit office before you route a load across it.
Key points:
- RIDOT's FAQ calls for escorts on loads 12 ft wide or more, 85 ft long or more, over 13 ft 6 in high, or with 15 ft or more of overhang.
- Loads over 10 ft wide, 80 ft long or 130,000 lb can't move from 7 to 9 a.m. or 3 to 7 p.m. on weekdays, and they stop for Thanksgiving week and other holidays.
- A load of 200,000 lb or more can need an independent analysis of every structure on the route.
- Crossing the Newport Pell or Mount Hope bridge takes a second permit, from the Rhode Island Turnpike and Bridge Authority (RITBA).
Rhode Island legal limits without a permit
These are the most a truck and load can measure and weigh on Rhode Island highways without a permit. A 2026 law raised the single-vehicle length limit from 40 ft to 45 ft, effective June 23, 2026.
| Limit | Legal in Rhode Island | Where it comes from |
|---|---|---|
| Width | 8 ft 6 in (102 in) | R.I. Gen. Laws § 31-25-3 |
| Height | 13 ft 6 in (162 in), including the load | R.I. Gen. Laws § 31-25-4 |
| Semitrailer length | 53 ft, not counting bumpers; a semitrailer over 48 ft 6 in can run only on Interstates and designated highways. Kingpin to the center of the rear axle can't exceed 41 ft, and a tractor and semitrailer have no overall length limit | R.I. Gen. Laws § 31-25-6 |
| Doubles | 28 ft 6 in for each trailer, on Interstates and designated roads only | R.I. Gen. Laws § 31-25-6 |
| Single vehicle length | 45 ft, including the load | R.I. Gen. Laws § 31-25-5 |
| Load overhang | 3 ft past the front; 6 ft past the rear of the bed or body | R.I. Gen. Laws § 31-25-7 |
| Gross weight | 80,000 lb, within the bridge formula | R.I. Gen. Laws § 31-25-14 |
| Axle weights | 22,400 lb on a single axle, or the axle's manufacturer rating if lower; 36,000 lb on a tandem with axles 8 ft or less apart | R.I. Gen. Laws §§ 31-25-13 and 31-25-14 |
How large a Rhode Island oversize permit load can be
RIDOT sets no fixed maximum for a single-trip permit. You can apply for any size or weight, and RIDOT engineers review each request. These checks shape what gets approved.
- Route surveys: RIDOT may require a survey for any load over the legal height. A load over 13 ft 6 in on a non-Interstate route typically needs one, and any load 14 ft or taller does.
- Weight over 130,000 lb: RIDOT approves single-trip permits above 130,000 lb case by case, on application and good cause shown.
- Annual blanket permits: for construction equipment, boats and marine assets moving within Rhode Island, a one-year blanket permit covers loads 55 ft to 80 ft long, up to 12 ft 4 in wide, up to 130,000 lb gross and up to 25,000 lb per axle. Blanket loads can't cross the Blackstone River Viaduct on I-295 or pass through construction zones with narrowed lanes.
- Divisible loads: an annual divisible load permit covers overweight only, never oversize, from April 1 to March 31.
When a Rhode Island load becomes a superload
RIDOT's FAQ says a permit load of 200,000 lb or more, depending on the route, needs an independent third-party analysis of every structure on the requested route. RIDOT's permit rule asks for extra-large load applications at least five working days before the move, so its engineers can check the route and clearances.
Rhode Island escort and pilot car requirements
RIDOT's current FAQ requires escorts when a load is 12 ft wide or more, 85 ft long or more, over 13 ft 6 in high, or has 15 ft or more of overhang. A permit reviewer can also add escorts when a move's circumstances call for them.
RIDOT's permit rule, 290-RICR-40-00-1, sets the number of escorts by dimension, on both multi-lane divided highways and two-lane roads.
| Load | Escorts under the RIDOT rule |
|---|---|
| 12 ft to 14 ft 6 in wide | 1 |
| Over 14 ft 6 in wide | 2 |
| 80 ft to 90 ft long | 1 |
| Over 90 ft long | 2 |
| Overhang of 15 ft or more | 1; 2 for a rear overhang of 15 ft or more on a two-lane undivided road when the load is 12 ft or more wide |
| Crane moving within Rhode Island, 12 ft wide or more | 2 |
| Building | 2, plus a police escort from each city or town |
The two RIDOT sources don't fully agree. The FAQ starts length escorts at 85 ft, while the rule starts them at 80 ft, and only the FAQ adds a height trigger. Follow the escorts printed on your permit.
When a load needs one escort, it runs in front on undivided highways and behind on divided highways. Under the rule, an escort vehicle must:
- be at least the size of a compact car;
- keep visual and two-way radio contact with the load at all times;
- run flashing yellow lights above its highest point, visible from the front and rear, with low-beam headlights on;
- carry an "OVERSIZE LOAD" sign at least 5 ft long and 12 in high, with black letters at least 10 in tall on yellow.
The load vehicle carries an "OVERSIZE LOAD" sign at least 7 ft long and 18 in high on the front of the truck and the rear of the load. It drives with low-beam headlights on and red or fluorescent orange flags, at least 18 in square, on the widest points and on any overhang over 4 ft.
When Rhode Island requires a police escort
RIDOT's rule requires police for moving a building: two escort vehicles plus a police escort from each city or town on the route. RIDOT's FAQ lists no police escort trigger for other loads.
When oversize loads can move in Rhode Island
Rhode Island combines a daylight rule with weekday rush-hour and holiday bans, and most limits depend on the load's size.
- Daylight: RIDOT's rule allows most permit loads from 30 minutes before sunrise to 30 minutes after sunset. Night travel is limited to overweight-only loads that can keep up with traffic.
- Weekends: the rule allows no permit moves from sunset Friday to sunrise Monday.
- Blanket permits: under the statute, annual blanket permit loads can move day and night on state highways.
- Rush hours: a load over 10 ft wide, 80 ft long or 130,000 lb can't travel from 7 to 9 a.m. or 3 to 7 p.m., Monday through Friday, on freeways and arterial roads. Until June 23, 2026, this ban started at 8 ft 6 in wide.
- Weather: permission to travel is always subject to weather and road conditions. A load caught in bad weather must exit at the first available location and park somewhere safe until conditions improve.
- Spacing and lanes: permit loads traveling the same direction keep 1,000 ft apart, and a load over 12 ft wide uses the right lane where there are two or more.
Rhode Island holiday restrictions
R.I. Gen. Laws § 31-25-21 sets these holiday bans for loads over 10 ft wide, 80 ft long or 130,000 lb.
| Holiday | No travel |
|---|---|
| Memorial Day, Victory Day, Labor Day, Martin Luther King Jr. Day and Columbus Day | Saturday, Sunday or Monday, day or night |
| Thanksgiving Day | Wednesday through Sunday of Thanksgiving week |
| Independence Day, Veterans Day, Christmas Day, New Year's Day and Juneteenth | The holiday, day or night, and the night before |
| Easter Sunday | Saturday night or Sunday |
The next restricted periods are Wednesday, November 25, through Sunday, November 29, 2026; the night of December 24 and all of December 25, 2026; the night of December 31, 2026, and all of January 1, 2027; and Saturday, January 16, through Monday, January 18, 2027.
RIDOT's FAQ lists the same holidays without the size qualifier. RIDOT's older permit rule uses a different holiday list for all permit loads and stops travel at noon the day before a midweek holiday, so check your permit's conditions.
Rhode Island bridge and construction restrictions
Several Rhode Island crossings have their own limits, as of November 20, 2026.
| Location | Restriction |
|---|---|
| Washington Bridge, I-195, Providence | 48 tons (96,000 lb) maximum. RIDOT's restrictions page: no oversize vehicles, until an anticipated December 2028. RIDOT's permit portal: oversize crossings by request, 11 p.m. to 5 a.m. on Sunday, Monday or Wednesday nights only, with the time stated in the permit and emailed to DOT.OSOW@dot.ri.gov |
| I-195, and I-95 from Massachusetts to Route 37 | Manufactured homes over 12 ft wide, construction equipment over 13 ft wide and cranes move only from sunrise to 7 a.m. and from 9 a.m. to 3:30 p.m. (RIDOT rule) |
| Newport Pell Bridge | RITBA permit required on top of the state permit; RITBA lists 160,000 lb as the maximum gross weight with a permit and 15 ft 6 in as the maximum height |
| Mount Hope Bridge | RITBA permit required for anything over 8 ft 6 in wide; 60,000 lb maximum, with no exceptions |
| Construction zones | Width limits of 10 ft to 12 ft on stretches of I-95, Routes 10, 37, 98, 114 and 146 and Eddy Street, most through December 31, 2026 |
RITBA can also limit permit crossings of its bridges to times outside commuter hours, which it defines as 6:30 to 9 a.m. and 3:30 to 6:30 p.m., Monday through Friday.
How to get a Rhode Island oversize permit
RIDOT issues single-trip and annual permits in the RIDOT OSOW Permit Portal.
- Gather the details. You need company and registration information and the dimensions of each vehicle and of the whole loaded combination. Single trips also need the axle spacings, axle weights and route.
- Create an account. Choose "Create Customer Account" on the portal's login page. Annual permits also need a gross vehicle weight rating (GVWR) certification from the manufacturer or its representative.
- Apply. The portal routes single trips automatically and flags bridge height conflicts. If you need a specific route, enter it yourself; you stay responsible for the route you submit.
- Pay. A credit card is the only immediate payment method. You can also set up an escrow account funded by credit card, ACH or check.
- Carry the permit. A single-trip permit is good for five days. Keep the permit and its documents in the vehicle; electronic copies are fine if they're readily available.
- Add other permits. RIDOT permits cover only state-maintained roads. City and town streets need local permits, and the Newport Pell and Mount Hope bridges need a RITBA permit (permits@ritba.org).
Rhode Island oversize permit fees
Rhode Island sets permit fees by statute.
| Permit | Fee |
|---|---|
| Single-trip permit, non-divisible load | $40 |
| Annual blanket permit, construction equipment, boats and marine assets under 130,000 lb | $400 |
| Annual divisible load permit, Rhode Island-registered vehicle | Included in the registration fee |
| Annual divisible load permit, out-of-state trailer | $100 |
| Annual divisible load permit, out-of-state truck or tractor | $50 per 1,000 lb over the legal limit, up to $1,500 for a single-unit truck or $1,250 for a tractor |
RIDOT's older permit rule still lists a $20 trip fee and a $100 blanket fee; the statute, amended since, sets the amounts above.
Planning an oversize move through Rhode Island
Rhode Island's 53 ft semitrailer limit applies only on Interstates and designated highways; elsewhere the limit is 48 ft 6 in. Connecticut draws that line at 48 ft, while Massachusetts allows a 53 ft trailer on any road it hasn't posted. Rhode Island's 41 ft kingpin limit is also tighter than the 43 ft Connecticut allows on its designated routes. All three states share a 13 ft 6 in legal height. See legal limits in all 50 states, or the Massachusetts and Connecticut guides.
Lead time in Rhode Island comes from engineering checks and narrow travel windows. A load 14 ft or taller needs a route survey, and one of 200,000 lb or more can need a structure-by-structure analysis. Extra-large loads should be filed at least five working days ahead, and a single-trip permit then lasts only five days. Build the schedule around the weekday rush-hour ban, the Washington Bridge, any RITBA bridge permit and Thanksgiving week.
Moving a load into, out of or across Rhode Island? Request a heavy haul quote with the dimensions, weight and route, or see our over dimensional freight service.
